Mier DA-500 Installationshandbuch

THE ORIGINAL VEHICLE DETECTION SYSTEM!DA-500 INSTALLATION MANUALTHE BASICS1 A sensor(s) detect(s) a vehicle entering a monitored area2 A control

Mier Products’ Drive-Alert Warranty Limited Warranty for Drive-Alert Models and Accessories Manufactured by Mier Products, Inc.Mier Products, Inc.’s L

10DA-500 DRIVE-ALERT TROUBLESHOOTING TREEStep 1 - Check to make sure the Power Light is on. If not, replace the internal 1A fuse, or send to Mier Pro

TABLE OF CONTENTSPage Content Cover Page1 Table of contents2 Introduction to the DA-500 and Accessories3-4 Installation Guide5 Operation In

Model DA-500 General InformationDrive-Alerts are perfect for use in residential driveways, on farms, at drive-up windows, in remote locations, and to

INSTALLATION page 1 of 2The Control Panel is generally located in a closet, utility room, or garage. If the only noisemaker used (remotes are availabl

INSTALLATION page 2 of 2When more than 1 probe is used, connect the red and black wires in series. Connect the silver wires in parallel. The red wire

OPERATION INSTRUCTIONSThe Drive-Alert is adjusted at the factory for maximum sensitivity for the probe and minimum time for the whistle. To adjust the

CONTROLLING EXTERNAL ALARMS & CHIMESCONNECTION USING DRY CONTACTS & EXTERNAL POWER NEG +24V NO NC CExternal 2

DA-500 Sensor and Remote DA-052V Whistle Connection RED BLK SHLD NEG +24 NO NC C - SENSOR - -- RELAY --1 2 3 4 5 6 7 8Senso

The DA-655 CHIME WITH VOLUME CONTROL is an optional feature for the Mier Products DA-500 and DA-600 Drive-Alert vehicle detection systems. When wired